Citation:

A-47. ASTM International (ASTM),  “ASTM E 2218, Standard Test Method for Determining Forming Limit Curves”.

Related Posts
Filter by
Post Page
Metallurgy Steel Grades AHSS Blog 1stGen AHSS 3rdGen AHSS Lower Strength Steels 2ndGen AHSS Conventional HSS homepage-featured-top main-blog Roll Forming Testing and Characterization Arc Welding
Sort by

Roll Forming

Roll Forming takes a flat sheet or strip and feeds it longitudinally through a mill containing several successive

8

Bend Testing

Tensile testing cannot be used to determine bendability, since these are different failure modes. Failure in bending

8

GMAW of Dissimilar AHSS Sheets

This is a summary of a paper of the same title, authored by K. Májlinger, E. Kalácska, and P. Russo Spena, used by p

8

Dual Phase

Dual Phase (DP) steels have a microstructure consisting of a ferritic matrix with martensitic islands as a hard

8

Complex Phase

Complex Phase (CP) steels combine high strength with relatively high ductility.  The

8

Carbon-Manganese (CMn)

Carbon-Manganese High Strength Steel Carbon and manganese are the two most cost-effective alloying

8