H-22

Citation:

H-22. G. Huang, S. Sriram, and H. Schreier, “Determination of Forming Limit and Fracture Limit Curves Using Digital Image Correlation,” SAE International Journal of Materials and Manufacturing, Vol. 7, no. 3 (2014), pages 574-582, doi.org/10.4271/2014-01-0982;

Filter by

Post Page

Formability homepage-featured-top main-blog Blog Forming Springback Steel Grades AHSS 3rdGen AHSS Roll Forming Roll Stamping Press Hardened Steels Production Managers Tool & Die Professionals 1stGen AHSS 2ndGen AHSS Joining Automotive Welding Process Comparison

Sort by

Forming Limit Curves (FLC)

topofpage

AHSS Edge Stretching Limits

A common problem in every stamping plant is trim edge burrs. As new materials have been introduced, special trim

Cold Stamped or Hot Formed? Part II

Cold Stamped or Hot Formed? Part 1

Equipment, Responsibilities, and Property Development Considerations When Deciding How A Part Gets

Performance Advantages

Steel, and specifically advanced high strength steel, satisfies automotive industry requirements for safety,

Emissions and Life Cycle Assessment

Vehicle programs must balance performance, safety, fuel efficiency, affordability and the environment, while

How Steel Properties Influence the Roll Forming Process

You’ll find this content as part of our p

Steel E-Motive Addresses Autonomous Vehicle Safety Challenges

As robotaxi companies in the USA prepare to launch their

Stronger AHSS Knowledge Required for Metal Stampers

This month’s blog was contributed by

Resistance Spot Welding: 3T and 4T Dissimilar Steel Stack-ups for Automotive Applications

Car body-in-white (

M-21 »

« W-26

Categories: Citations

Tags: G. HuangH. SchreierS. SriramSAESociety of Automotive Engineers

Angela Erhart:

T-48
Citation T-48. “Body Structure Materials and Allowed Operations” section in the “Model Y Collision Repair…
W-11
Citation W-11. WorldAutoSteel. (2010) “FutureSteelVehicle Results and Reports & Cost Models.”
J-25
Citation J-25: Japan European New Car Assessment Program