C-20

Citation:

C-20. D. Chantzis, X. Liu, D. J. Politis, O. El Fakir, T. Y. Chua, Z. Shi, and L. Wang, “Review on additive manufacturing of tooling for hot stamping,” The International Journal of Advanced Manufacturing Technology, Volume 109, 2020. Pages 87–107, doi.org/10.1007/s00170-020-05622-1.

Filter by

Post Page

homepage-featured-top main-blog Blog Additive Manufacturing Manufacturing Issues Steel Grades AHSS Joining Joining Dissimilar Materials Citations

Sort by

Additive Manufacturing

Additive Manufacturing (AM) has been associated with the future of manufacturing since its inception. While it does

Additive Manufacturing for Sheet Metal Forming Tools

Polymer

Manufacturing Issues

Spot Welding of Three Steel Sheets with Large

Resistance Spot Welding with Advanced High-Strength Steels: Cold Stamped and Hot Formed

The discussions relative to cold stamping are applicable to any forming operation occurring at room temperature

Cold Stamped or Hot Formed? Part II

M-65-2

Citation M-65-2.

Cold Stamped or Hot Formed? Part 1

Equipment, Responsibilities, and Property Development Considerations When Deciding How A Part Gets

Current Vehicle Examples

Manufacturers embrace Advanced High Strength Steels as a cost-effective way to satisfy functional and regulatory

Emissions and Life Cycle Assessment

Vehicle programs must balance performance, safety, fuel efficiency, affordability and the environment, while

Steel E-Motive

Steel E-Motive represents a fully autonomous ride sharing vehicle concept

N-19 »

« P-25

Categories: Citations

Tags: D. ChantzisD. J. PolitisL. WangO. El FakirT. Y. ChuaX. LiuZ. Shi

Angela Erhart:

T-48
Citation T-48. “Body Structure Materials and Allowed Operations” section in the “Model Y Collision Repair…
W-11
Citation W-11. WorldAutoSteel. (2010) “FutureSteelVehicle Results and Reports & Cost Models.”
J-25
Citation J-25: Japan European New Car Assessment Program