H-22

Citation:

H-22. G. Huang, S. Sriram, and H. Schreier, “Determination of Forming Limit and Fracture Limit Curves Using Digital Image Correlation,” SAE International Journal of Materials and Manufacturing, Vol. 7, no. 3 (2014), pages 574-582, doi.org/10.4271/2014-01-0982; 

Related Posts
Filter by
Post Page
Formability homepage-featured-top main-blog Blog Forming Springback Steel Grades AHSS 3rdGen AHSS Roll Forming Roll Stamping Press Hardened Steels Production Managers Tool & Die Professionals 1stGen AHSS 2ndGen AHSS Joining Automotive Welding Process Comparison
Sort by

Forming Limit Curves (FLC)

topofpage

18

AHSS Edge Stretching Limits

A common problem in every stamping plant is trim edge burrs. As new materials have been introduced, special trim

18

Cold Stamped or Hot Formed? Part II

8

Cold Stamped or Hot Formed? Part 1

Equipment, Responsibilities, and Property Development Considerations When Deciding How A Part Gets

8

Performance Advantages

Steel, and specifically advanced high strength steel, satisfies automotive industry requirements for safety,

8

Emissions and Life Cycle Assessment

Vehicle programs must balance performance, safety, fuel efficiency, affordability and the environment, while

8

How Steel Properties Influence the Roll Forming Process

You’ll find this content as part of our p

8

Steel E-Motive Addresses Autonomous Vehicle Safety Challenges

As robotaxi companies in the USA prepare to launch their

8

Stronger AHSS Knowledge Required for Metal Stampers

This month’s blog was contributed by

8

Resistance Spot Welding: 3T and 4T Dissimilar Steel Stack-ups for Automotive Applications

Car body-in-white (

8