T-40 Citation: T-40. K. Teshima, “Challenges of high-efficiency hot forming processes at Honda,” Presented at Forming in Car Body Engineering 2012, September 26-27, Bad Nauheim, Germany, 2012. Related Posts Filter by Post type Post Page Category homepage-featured-top main-blog Blog Roll Forming Tube Forming Additive Manufacturing Formability Forming Hydroforming Forming Modes Sort by Title Relevance Roll Forming Roll Forming takes a flat sheet or strip and feeds it longitudinally through a mill containing several successive 18 Tube Forming Manufacturing precision welded tubes typically involves continuous 18 Vision for Industry 4.0 in Sheet Metal Forming There is interest in the sheet metal industry on how to adopt Industry 4.0 into their legacy forming practices to 18 Additive Manufacturing for Sheet Metal Forming Tools Polymer 18 Forming Limit Curves (FLC) topofpage 18 Forming and Formability of AHSS Introduction Approaches for forming higher strength steels evolved with the commercialization of increased 18 Hydroforming Tube hydroforming creates complex shapes by using internal pressure to expand a tube against a die cavity. Frame 18 Forming Modes Stamping and die designers are interested in the forming capabilities of the steels they specify. Complex stampings 18 Case Study: Upgraded Tool Steels for Upgraded Sheet Metal Forming We thank 18 AHSS Fundamentals in Forming and Joining In this edition of AHSS Insights, George Coates and Menachem Kimchi get back to basics with important 18 Submit a Comment Cancel replyYour email address will not be published. Required fields are marked *Comment * Name * Email * Website Notify me when new comments are added. Δ