T-20

Citation:

T-20. Uddeholm AB, “Tooling Solutions For Advanced High Strength Steels“, Edition 4, June 2018.

 

 

Related Posts
Filter by
Post Page
homepage-featured-top main-blog Blog Citations Steel Grades AHSS 1stGen AHSS Resistance Welding Steel to Aluminium
Sort by

Steel E-Motive Closures: Balancing openness and accessibility to create a safe & strong autonomous vehicle

We at WorldAutoSteel, side-by-side with our engineering partner

8

Using Martensitic Steels as an Alternative to Press Hardening Steel – Laboratory Evaluations

Our colleagues at JFE Steel recently provided us with a new case study based on laboratory evaluations they

8

T-44

Citation: T-44. S. Tobita, T. Shinmiya, and Y Yamasaki, “Press M

8

T-29

Citation: T-29. S. Tobita, T. Shinmiya, Y. Yamasaki and J. Hiramoto,

8

J-24

Citation: J-24.  JFE Steel Corporation,  News Release, “

8

K-57

Citation: K-57. Courtesy of T. Kondo,

8

Martensite

Metallurgy of Martensitic Steels Case Study:

8

Conventional Rule-of-Thumb Calculations Lead to Inaccurate Press Tonnage Predictions

The rule of thumb estimates used in 1989 during my internship with an automotive stamping supplier were simple

8

Servo Press Force and Energy Considerations When Working With AHSS

Advanced High-Strength Steel (AHSS) products have significantly different forming characteristics and these

8

Process, Microstructure and Fracture Mode of Thick Stack-Ups of Aluminum Alloy to AHSS Dissimilar Spot Joints

This article summarizes a paper entitled, “Process, Microstructure and Fracture Mode of Thick Stack-Ups of

8

Trackbacks/Pingbacks

  1. Cutting, Blanking, Shearing, and Trimming - AHSS Guidelines - […] Figure 10: Cut edge appearance after punching CR 1400T-MS with 6% (left) and 14% (right) die clearance. The bottom…
  2. Tooling and Die Wear - AHSS Guidelines - […] Figure 2: PVD-applied TiAlN-coated cutting steel (image A) reduces galling compared with an uncoated cutting steel (image B). Edges…

Submit a Comment

Your email address will not be published.