S-39

Citation:

S-39. T.B. Stoughton, “A general forming limit criterion for sheet metal forming,” International Journal of Mechanical Sciences, Volume 42, Issue 1, January 2000, p. 1, doi.org/10.1016/S0020-7403(98)00113-1.

Related Posts
Filter by
Post Page
main-blog Forming Springback Steel Grades AHSS Blog 3rdGen AHSS Roll Forming Roll Stamping Press Hardened Steels homepage-featured-top Tube Forming Additive Manufacturing Formability Hydroforming Forming Modes
Sort by

Case Study: Upgraded Tool Steels for Upgraded Sheet Metal Forming

We thank

18

How Steel Properties Influence the Roll Forming Process

You’ll find this content as part of our p

18

Roll Forming

Roll Forming

18

Tube Forming

Manufacturing precision welded tubes typically involves continuous

18

Vision for Industry 4.0 in Sheet Metal Forming

There is interest in the sheet metal industry on how to adopt Industry 4.0 into their legacy forming practices to

18

Additive Manufacturing for Sheet Metal Forming Tools

Polymer

18

Forming Limit Curves (FLC)

topofpage

18

Forming and Formability of AHSS

Introduction Approaches for forming higher strength steels evolved with the commercialization of increased

18

Hydroforming

Tube hydroforming creates complex shapes by using internal pressure to expand a tube against a die cavity. Frame

18

Forming Modes

Stamping and die designers are interested in the forming capabilities of the steels they specify. Complex stampings

18

Case Study: Upgraded Tool Steels for Upgraded Sheet Metal Forming

We thank

18

How Steel Properties Influence the Roll Forming Process

You’ll find this content as part of our p

18