L-20

Citation:

L-20. P. Larour, “Strain rate sensitivity of automotive sheet steels: influence of plastic strain, strain rate, temperature, microstructure, bake hardening and pre-strain,” Doctoral Dissertation, 2010, IEHK RWTH Aachen University, ISBN 978-3-8322-9149-5.

Related Posts
Filter by
Post Page
homepage-featured-top main-blog Mechanical Properties AHSS Blog Testing and Characterization Formability true fracture strain FLC and FLD
Sort by

Tensile Testing: Engineering Stress-Strain Curves vs. True Stress-Strain Curves

Tensile testing is one of the most basic formability characterization methods

18

High Strain Rate Testing

Dynamic tensile testing of sheet steels is becoming more important due to the need for more optimized vehicle

18

True Fracture Strain

topofpage

18

Circle Grid Strain Analysis (CGSA)

A

18

Non-Linear Strain Paths (Stress-Based FLCs)

Conventional

18

Engineering Stress-Strain vs. True Stress-Strain

Strength is defined as load divided by cross-sectional area. In a tensile test, the choice of when the

18

AHSS Strain Hardening and Gradients

The mild steel currently being used for sheet metal stampings has higher n-values than High Strength Low Alloy Steel

18

Cold Stamped or Hot Formed? Part II

8

Performance Advantages

Steel, and specifically advanced high strength steel, satisfies automotive industry requirements for safety,

8

Rationale

Automakers face conflicting constraints when designing new body structures: With escalating concerns

8