K-15

Citation:

K-15. B. Krause and T. Bell, “Increasing the Efficiency of Metalform Tooling for Advanced High-Strength Steels“, Presented at 2005 Great Designs in Steel, Sponsored by American Iron and Steel Institute. 

Related Posts
Filter by
Post Page
homepage-featured-top main-blog Blog Citations Steel Grades AHSS 1stGen AHSS
Sort by

Steel E-Motive Closures: Balancing openness and accessibility to create a safe & strong autonomous vehicle

We at WorldAutoSteel, side-by-side with our engineering partner

1

Designing For Vehicle Crash Requirements that Don’t Yet Exist

1

Using Martensitic Steels as an Alternative to Press Hardening Steel – Laboratory Evaluations

Our colleagues at JFE Steel recently provided us with a new case study based on laboratory evaluations they

1

T-44

Citation: T-44. S. Tobita, T. Shinmiya, and Y Yamasaki, “Press M

1

T-29

Citation: T-29. S. Tobita, T. Shinmiya, Y. Yamasaki and J. Hiramoto,

1

J-24

Citation: J-24.  JFE Steel Corporation,  News Release, “

1

K-57

Citation: K-57. Courtesy of T. Kondo,

1

Martensite

Metallurgy of Martensitic Steels Case Study:

1

What are 3rd Gen AHSS?

One of the tasks we took great care in completing during the update of the AHSS Application Guidelines was to

1

Conventional Rule-of-Thumb Calculations Lead to Inaccurate Press Tonnage Predictions

The rule of thumb estimates used in 1989 during my internship with an automotive stamping supplier were simple

1

Trackbacks/Pingbacks

  1. Cutting - AHSS Guidelines - […] Figure 16: A chamfered punch reduces peak loads and snap-through tonnage.K-15 […]

Submit a Comment

Your email address will not be published.