H-27

H-27. S. Hamamoto, H. Omori, T. Asai, N. Mizuta, N. Jimbo and T. Yamano, “Steel Sheets for Highly Productive Hot Stamping,” Kobelco Technology Review, vol. 35, p. 39–44, 2017.

Filter by

Post Page

homepage-featured-top main-blog Blog Steel Grades AHSS 1stGen AHSS Press Hardened Steels Forming Metallurgy Tailored Products Citations

Sort by

Additive Manufacturing (AM) has been associated with the future of manufacturing since its inception. While it does

Introduction

There is interest in the sheet metal industry on how to adopt Industry 4.0 into their legacy forming practices to

PHS and PQS Overview A Brief Overview of Press Hardening Press hardening (also commonly

There are different ways to classify automotive steels. One is a metallurgical designation providing some process

Citation: R-28. K. Roll, “

Citation: G-3. I. Martin Gonzalez, “

Citation: B-75. H. Bodin, “

Citation: P-4. F. Pinard, L. Cretteur, and J. Y. Sener, “State of th

Coatings for PHS - AHSS Guidelines - […] An estimated ~40% of press hardened components are in dry areas. Thus, high corrosion protection is desired in the…
PHS Aluminium-Based Coatings - AHSS Guidelines - […] An estimated ~40% of press hardened components are in dry areas. Thus, high corrosion protection is desired in the…
PHS Grades - AHSS Guidelines - […] 5°C/s, even at a cooling rate of 1°C/s, hardness over 450HV can be achieved, as shown in Figure 7.H-27 …
PHS Production Methods - AHSS Guidelines - […] to 1.3.9.2.1 PHS Grades with approximately 1500 MPa TS] is a new steel grade developed by Kobe SteelH-27 for…