C-4

C-4. H. S. Choi, W. S. Lim, P. K. Seo, C. G. Kang and B. M. Kim, “Local softening method for reducing trimming load and improving tool wear resistance in cutting of a hot stamped component,” Steel Research Int. Special Edition, pp. 419-422, 2011.

Filter by

Post Page

Testing and Characterization homepage-featured-top main-blog Blog High Energy Density Welding Citations Arc Welding

Sort by

Three important points collectively highlight the need for high-speed testing:

Tensile testing cannot be used to determine bendability, since these are different failure modes. Failure in bending

topofpage

The Hole Expansion test (HET) quantifies the edge stretching capability of a sheet metal grade having a specific

Bubble chart. Banana diagram. Steel strength ductility diagram—it’s been called a lot of things over the years. But t

This is a summary of a paper by M. Mazar Atabaki, et al, entitled, “Pore formation and its mitigation during

Citation: M-66. M. Mazar Atabaki, J. Ma, W. Liu, R. Kovacevic,

This is a summary of a paper of the same title, authored by K. Májlinger, E. Kalácska, and P. Russo Spena, used by p

Citation: M-65. K. Májlinger, E. Kalácska, P. Russo Spena, “Gas met

Additive Manufacturing (AM) has been associated with the future of manufacturing since its inception. While it does