H-22

Citation:

H-22. G. Huang, S. Sriram, and H. Schreier, “Determination of Forming Limit and Fracture Limit Curves Using Digital Image Correlation,” SAE International Journal of Materials and Manufacturing, Vol. 7, no. 3 (2014), pages 574-582, doi.org/10.4271/2014-01-0982;

Filter by

Post Page

Formability homepage-featured-top main-blog Blog Press Hardened Steels Press Hardening Steel PHS Press Quenched Steel PQS grades Manganese-Boron furnace 22MnB5 AlSi direct press hardening indirect press hardening multi-step press hardening high ductility PHS 20MnB8 pre-cooled stamping 22MnSiB9-5 Unisteel SIBORA “Bainitizing Quenching and Partitioning” BQP Bainitizing Forming Springback Steel Grades AHSS 3rdGen AHSS Roll Forming Roll Stamping Production Managers Tool & Die Professionals 1stGen AHSS 2ndGen AHSS

Sort by

Forming Limit Curves (FLC)

topofpage

AHSS Edge Stretching Limits

A common problem in every stamping plant is trim edge burrs. As new materials have been introduced, special trim

Press Hardening Steel Grades: Unlocking Strength Through Innovation

You’ll find most of this content as part of our page on

Cold Stamped or Hot Formed? Part II

Cold Stamped or Hot Formed? Part 1

Equipment, Responsibilities, and Property Development Considerations When Deciding How A Part Gets

Performance Advantages

Steel, and specifically advanced high strength steel, satisfies automotive industry requirements for safety,

Emissions and Life Cycle Assessment

Vehicle programs must balance performance, safety, fuel efficiency, affordability and the environment, while

How Steel Properties Influence the Roll Forming Process

You’ll find this content as part of our p

Steel E-Motive Addresses Autonomous Vehicle Safety Challenges

As robotaxi companies in the USA prepare to launch their

Stronger AHSS Knowledge Required for Metal Stampers

This month’s blog was contributed by

Citation:

Search